C-6000-PCS Carousel….Robot load/ unload This Carousel system cleans diesel engine pistons inside and out including a cavity that only has access via two (2) small, ¼” diameter holes. Parts are robotically loaded and unloaded from the same front position. The turntable indexes every 45 seconds moving the parts through the wash, rinse, and dry zones.
Saturday, 23 December 2017 by bettereng1neer1ng
CAROUSEL WASHER C-5000-P-SS Carousel type cleaning system washes and dries ring gears, pinion shafts and differential housings. The system is manually loaded and unloaded from the same open, front station. A 50” diameter turntable holds a total of 16 parts at any given time. It brings the parts through the wash and dry zones and
Background: This company specializes in making exhaust pipes for motorcycles. They wanted to phase out solvent tanks and use an environmentally friendly, water-based cleaning system. Parts Cleaning Problem: Find a way to rack and clean a myriad of tubes (some straight and some bent) and design the washer so that the racks can be conveyed
Automotive Transaxle Parts Cleaning Carousel parts cleaning system with four (4) small turntables mounted to the large 60″ diameter carousel turntable. At any given time, one turntable can be loaded/unloaded by the operator while the other turntables are rotating in the wash, rinse, and dry zones. The unit outputs one set of clean/ dry parts
Spine Shaft Cleaning Compact conveyor washer designed to fit in customer’s existing work cell (between a knurling machine and a induction heating unit). The customer’s pick and place unit automatically places the shafts onto the washer’s conveyor. The parts get washed , blown-off and then slide down a chute into the customer’s vibratory conveyor.
Transmission Housing Cleaning The RTO-2000 is the perfect parts washer for a work cell. The operator loads a part, rolls the dolly into the chamber, and uses push-button controls to close the door and start the cycle. In cycle, the part rotates and water is blasted into key passageways. In just 3 minutes, the part is
Conveyor Washers for Camshafts, Crankshafts and Engine Blocks Two (2) identical conveyor washers with custom fixturing – one designed to hold camshafts and crankshafts and the other to clean engine blocks. These systems wash, rinse, and dry 120 parts, or sets of parts, every hour (the next step is assembly.) Electronic sensors and operator flag
C-24 Conveyor Washer This C-24 conveyor washer is cleaning stampings coming off a press at the rate of 150 parts per minute. The parts are conveyed from the press to the washer, fall onto the washer’s conveyor belt, which then inclines into the system. The parts go through a four (4) stage cleaning process. The
CJ-2 Tumbling Washer with Automated Conveyor This CJ-2 cleans fuel injector parts to the highest possible standards. This system cleans trays of parts since this is how they are normally handled in the manufacturing plant. The operator places a tray (single or double stacked) on the blue conveyor belt and walks away. The conveyor then
C-14 Conveyor Washer with 360 Degree Track This Cyberjet C-14 is a fully automated parts washing system that cleans diesel engine camshafts. A single robot loads and unloads the camshafts on one end of the system. Once a camshaft is loaded onto a fixture, the fixture is released and the part travels around the tight