14-inch wide belt and hinged, lift-up canopy lids are standard.

Select from five different available modules - spray/recirculated, fresh water rinse, compressed air dry, non-heated dry, and heated dry - to configure the conveyor cleaning system to meet your needs.

The Cyber-jets are truly modular in that they can be expanded or changed without a torch and welder. There are no welded connections and the conveyor rails and wire ways terminate at each module.

With few exceptions, all the "wetted" parts of the system are stainless steel.* The metalwork, pumps, spray manifolds, conveyor belt, support rollers, conveyor drive shaft, and solenoid valves are all stainless steel.

*The only exceptions are: 1) steam exhaust fans are aluminum, 2) blowers for drying are mild steel, and 3) some duct work is PVC.

Choose from a wide variety of conveying options to design the right parts washing system for your application such as flat wire belting, plastic belting, chain conveyor, roller conveyor, table-top conveyor, double belting, and more.

Stainless steel spray manifolds remove dirt, grease, carbon, etc. from parts.

Vertical seal-less pumps with TEFC motors.

Better Engineering offers drying modules as well as simple blow-off sections. The drying models have 1) centrifugal blowers for 15,000 FPM air velocity, 2) recirculation system to conserve heat and prevent blow-out, 3) optional air heater to boost air temperature, 4) top and bottom air knives, 5) pitched floor, and 6) full insulation.

Top belt holds stampings in place during cleaning process.